Installing Boat Graphics to Our Ranger Tug Kismet

Boat Graphics are Finally Applied!

After designing, measuring, and visually laying out the boat graphics on the back of the boat, we were ready to order the vinyl from a sign company located just a block away from the marina. Jim has done this before so he was familiar with the process.

First, thoroughly clean the back of the boat (above).

Second, measure and block off the area, then tape the double-layer vinyl to the clean surface (below).

Third, drop the vinyl down and peel off the protective paper layer (above).

Four, tape it back up (above) and start burnishing the vinyl onto Gelcoat, through the protective cover layer.

Lastly, carefully peel the top protective layer off with the burnishing tool, a little detail work will make it perfect.

Voila! Kismet finally bears her name.